sanlk-resetd man page
sanlk-resetd — host reset daemon
sanlk-resetd [Options] lockspace_name ...
The sanlk-resetd daemon gets events from specified sanlock lockspaces. Events are defined to cause sanlk-resetd to:
- use wdmd/watchdog to reset the host
- use /proc/sysrq-trigger to reboot the host
The sanlk-reset program can be run on another host to request that sanlk-resetd reset the host it is running on. Both hosts must be operational and have continued access to a common lockspace for the reset request to succeed. After setting the event, the sanlk-reset program monitors the host status in the sanlock lockspace until the target host is dead.
The sanlk-reset program can also be run on the same host as sanlk-resetd to update which lockspaces the local sanlk-resetd is watching for events.
- --version, -V
- --help, -h
- --foreground, -f
- --daemon-debug, -D
Enable debugging to stderr and don't fork.
- --sysrq-reboot, -b 0|1
Enable/Disable (1/0) use of /proc/sysrq-trigger to reboot.
- --sysrq-delay, -d sec
Delay this many seconds before using /proc/sysrq-trigger.
- --resource-mode, -R 0|1
Resource leases are used (1) or not used (0) to protect storage.
sanlk-reset(8) sanlock(8) wdmd(8)