rfiod man page
RFIOD(8) Rfio Administrator Commands RFIOD(8)
rfiod- Remote file access daemon
[1mrfiod [22m[ [1m-d [22m] [ [1m-f [4m[22mfilename[24m ] [ [1m-l [22m] [ [1m-p [4m[22mport[24m ] [ [1m-s [22m] [ [1m-t [22m] [ [1m-4 [22m| [1m-6[0m
] [ [1m-L [4m[22mlog_level[24m ]
rfiod start the daemon handling remote file access requests. This com-
mand is usually executed at system startup time ([1m/etc/rc.local[22m). rfiod
uses for the streaming mode (v3) one control port and one data port.
The range of data ports to be used by rfiod can be set with the envi-
ronment variable RFIO_PORT_RANGE.
[1m-d [22mTurn on printing of debug messages. Default output device is
Output filename for error, logging and debugging messages. Nor-
mal error messages are sent to syslog unless otherwise speci-
fied. Two filenames are special : "stderr", which will send
messages to standard error and "syslog" which will send to sys-
[1m-l [22mTurn on printing of log messages. Default output device is in
Specify a network port for the service to listen on. If this
option is not given the value RFIO_PORT defined in rfio_con-
stants.h is used.
[1m-s [22mTurn on Standalone mode. This option should always be set when
rfiod is not started by inetd.
[1m-t [22mTurn on single threaded mode. Useful for debugging as no pro-
cesses are created.
[1m-4 [22monly try to listen on IPv4 addresses
[1m-6 [22monly try to listen on IPv6 addresses
Specify the logging level. Default 6 (LOG_INFO).
[1mLCG Grid Deployment [22mTeam
LCG $Date: 2012-06-06 16:39:34 +0200 (Wed, 06 Jun 2012) $ RFIOD(8)