dump.f2fs - Man Page

dump.f2fs [ -i inode number ] [ -I inode number ] [ -n NAT range ] [ -M Block map ] [ -s SIT range ] [ -a SSA range ] [ -b block address ] [ -d debugging-level ] device

dump.f2fs is used to retrieve f2fs metadata (usually in a disk partition). device is the special file corresponding to the device (e.g. /dev/sdXX).

Currently, it can retrieve 1) a file given its inode number, 2) NAT entries into a file, 3) SIT entries into a file, 4) SSA entries into a file, 5) reverse information from the given block address.

The exit code returned by dump.f2fs is 0 on success and -1 on failure.

-i inode number

Specify an inode number to dump out.

-I inode number

Specify an inode number and scan full disk to dump out, include history inode block

-n NAT range

Specify a range presented by nids to dump NAT entries.

-M Block map

Show all the allocated block addresses given inode number.

-s SIT range

Specify a range presented by segment numbers to dump SIT entries.

-a SSA range

Specify a range presented by segment numbers to dump SSA entries.

-b block address

Specify a block address to retrieve its metadata information.

-d debug-level

Specify the level of debugging options. The default number is 0, which shows basic debugging messages.

Initial checking code was written by Byoung Geun Kim <bgbg.kim@samsung.com>.

dump.f2fs is available from git://git.kernel.org/pub/scm/linux/kernel/git/jaegeuk/f2fs-tools.git.

mkfs.f2fs(8), fsck.f2fs(8), defrag.f2fs(8), resize.f2fs(8), sload.f2fs(8).

defrag.f2fs(8), fsck.f2fs(8), mkfs.f2fs(8), resize.f2fs(8), sload.f2fs(8).