ipmctl-show-error-log - Man Page

ipmctl show [OPTIONS] -error (Thermal|Media) [TARGETS] [PROPERTIES]

Shows thermal or media errors on the specified PMem modules.

-a,  -all

Shows all attributes.

-h,  -help

Displays help for the command.

-ddrt

Used to specify DDRT as the desired transport protocol for the current invocation of ipmctl.

-smbus

Used to specify SMBUS as the desired transport protocol for the current invocation of ipmctl.
Note

The -ddrt and -smbus options are mutually exclusive and may not be used together.

-lpmb

Used to specify large transport payload size for the current invocation of ipmctl.

-spmb

Used to specify small transport payload size for the current invocation of ipmctl.
Note

The -lpmb and -spmb options are mutually exclusive and may not be used together.

-o (text|nvmxml), -output (text|nvmxml)

Changes the output format. One of: "text" (default) or "nvmxml".

-dimm [DimmIDs]

Filter output to specific PMem modules by optionally supplying one or more comma separated PMem module identifiers. The default is to include all manageable PMem modules.

SequenceNumber

Error log entries are stored with a sequence number starting with 1 and rolling over back to 1 after 65535. Limit the error log entries returned by providing a sequence number. Only errors with a sequence number equal to or higher than provided will be returned. The default is 1.

Level

Severity level of errors to be fetched. One of:

• "High": High severity errors (Default)
• "Low": Low severity errors

Count

Max number of error entries to be fetched and printed. The default is 8 for media errors and 16 for thermal errors.

Show all high thermal error log entries

ipmctl show -error Thermal Level=High

Show all low media error log entries

ipmctl show -error Media Level=Low

To successfully execute this command, the specified PMem modules must be manageable by the host software. In addition, for PMem modules with firmware version 2.3 and above, errors due to AIT operations are no longer exposed.

Prints errors of the specified type for the specified PMem modules. If no errors are found, the following message will be printed:

No errors found on PMem module (DimmID)

 DimmID | System Timestamp    | Error Type
=============================================================
 0x0001 | 01/01/1970 00:00:20 | 0x04 - Locked/Illegal Access
 0x0001 | 01/01/1970 00:00:21 | 0x04 - Locked/Illegal Access
Show error executed successfully

Media Error occurred on Dimm (DimmID):
System Timestamp : 1527266471
DPA : 0x000014c0
PDA : 0x00000600
Range : 4B
Error Type : 4 - Locked/Illegal Access
Error Flags : DPA Valid
Transaction Type : 11 - CSR Write
Sequence Number : 2

ipmctl(1).