git-lfs-merge-driver - Man Page

Merge text-based LFS files

Synopsis

git lfs merge-driver options

Description

Merge text files stored in Git LFS using the default Git merge machinery, or a custom merge driver if specified. Note that this, in general, does not support partial renames or copies because Git does not support them in this case.

This program is intended to be invoked automatically by Git and not by users manually. See Configuration for details on the configuration required for that.

Options

Configuration

Git allows the use of a custom merge driver for files based on the merge attribute set in .gitattributes. By default, when using git lfs track, this value is set to lfs.

Because Git LFS can be used to store both text and binary files and it isn´t always clear which behavior should be used, Git LFS does not enable this merge driver by default. However, if you know that some or all of your files are text files, then you can set the merge attribute for those files to lfs-text and use git config to set the merge driver like so:

console $ git config merge.lfs-text.driver ´git lfs merge-driver --ancestor %O --current %A --other %B --marker-size %L --output %A´

This tells Git to invoke the custom Git LFS merge driver, which in turn uses Git´s merge machinery, to merge files where the merge attribute is set to lfs-text. Note that lfs-text here is an example and any syntactically valid value can be used.

If you are using a special type of file that needs rules different from Git´s standard merge machinery, you can also specify the --program option, which is passed to sh after substituting its own percent-encoded escapes:

Note that the percent sign must typically be doubled to prevent Git from substituting its own values here. Therefore, specifying the default behavior explicitly looks like this:

console $ git config merge.lfs-text.driver \ ´git lfs merge-driver --ancestor %O --current %A --other %B --marker-size %L --output %A --program ´\´´git merge-file --stdout --marker-size=%%L %%A %%O %%B >%%D´\´´´

The exit status from the custom command should be zero on success or non-zero on conflicts or other failure.

Note that if no merge driver is specified for the value of the merge attribute (as is the case by default with merge=lfs), then the default Git merge strategy is used. For LFS files, this means that Git will try to merge the pointer files, which usually is not useful.

See Also

git-merge(1), git-merge-file(1), gitattributes(5)

Part of the git-lfs(1) suite.

Referenced By

git-lfs(1).

May 2022