dpm-modifyfs man page

DPM-MODIFYFS(1)           DPM Administrator Commands           DPM-MODIFYFS(1)

[1mNAME[0m
      dpm-modifyfs - modify the parameters of a disk pool filesystem

[1mSYNOPSIS[0m
      [1mdpm-modifyfs --server [4m[22mfs_server[24m [1m--fs [4m[22mfs_name[24m [ [1m--st [4m[22mstatus[24m ] [ [1m--weight[0m
      [4mweight[24m ] [ [1m--help [22m]

[1mDESCRIPTION[0m
      [1mdpm-modifyfs [22mmodifies the parameters of a disk pool filesystem.

      This command requires ADMIN privilege.

[1mOPTIONS[0m
      [4mserver[24m specifies the host name of the disk server where this filesystem
             is mounted.

      [4mfs[24m     specifies the mount point of the dedicated filesystem.

      [4mstatus[24m New  status  of  this  filesystem.  It  can be set to 0 (enabled
             read/write) or [1mDISABLED [22mor [1mRDONLY[22m.  This can be either  alphanu-
             meric or the corresponding numeric value.

      [4mweight[24m specifies  the weight of the filesystem. This is used during the
             filesystem selection. The value must be positive.  It is  recom-
             mended to use a value lower than 10.

[1mEXAMPLE[0m
           dpm-modifyfs --server sehost --fs /data --st RDONLY

[1mEXIT STATUS[0m
      This  program  returns  0  if the operation was successful or >0 if the
      operation failed.

[1mSEE ALSO[0m
      [1mdpm(1)[22m, [1mdpm_modifyfs(3)[0m

LCG          $Date: 2011-05-19 13:04:02 +0200 (Thu, 19 May 2011)DP$M-MODIFYFS(1)